DIY Drop Leaf Table Ikea

0

Drop leaf table Ikea – The drop-leaf table often has a center support from the leaf or leaves hang. But they can built with only a sheet hanging from the wall. Cut a piece of wood to the desired size of the blade. Then prepare it to keep up with sanding and painting, oiling or painting it as you want. Cut a wall bracket that is the same length as the side of the table leaves that will be flush with the wall.

Trim a section of the drop leaf table Ikea the surface of the head section which is the same width. Attach the trimmed section to the wall bracket with screws. So that it protrudes enough support to secure the leaves with hinges. The hinges should be attached to the bottom side of the leaf surface. So they are not visible when the table is open.

Fix the upper support drop leaf table Ikea to the wall if you do not connect it to an existing table. Screw the studs in the wall, which is usually 16 inches apart on center. Build a support triangle below the wall support that can swing out to hold the table up when in use, and swing shut under the table when it is not. Attach the blade section to the hinges on the wall support.

Share.

Comments are closed.