Installing IKEA Wall Anchor

0

IKEA wall anchor – It is important to core a hole through a brick wall before you insert a wall anchor. When the core of an increasingly anchors. It is very important that you use a masonry bit and a drill hammer or hammer drill. Standard drills and hand drills do oblong hole and basically chip out a useless hole. With the right equipment you can make quick work of seating wall anchors.

Attach a masonry bit on a drill hammer or hammer drill. It is important that the drill bit to match the diameter of the IKEA wall anchor you plan to use. Place the wall anchor to the end of the drill bit and mark the depth of the wall anchor in the drill bit with tape. This will ensure that you drill deep enough into the wall, but not more than necessary.

Keep masonry piece perpendicular to the wall and pull the trigger. Hold the drill firmly and apply sufficient inward pressure on the back of the drill until you reach the desired depth. Suck the powder within the hole with a wet / dry vacuum. Fill the hole with 100 percent silicone caulk and then slide the IKEA wall anchor in the hole. The seal will fill the hole and protect it from moisture, but will still allow you to remove the screw from the anchor if necessary. The anchor fits tightly if you used the right masonry drill bit and kept straight. If necessary, tap the anchor into the wall with a hammer.

Share.

Comments are closed.